Ground sheet origami

Share your advice and personal experiences, post a gear review or ask any questions you may have pertaining to outdoor gear and equipment.
Post Reply
User avatar
Topix Addict
Posts: 2191
Joined: Wed Dec 17, 2008 9:22 pm
Experience: N/A

Ground sheet origami

Post by balzaccom » Tue Apr 28, 2020 7:51 am

With time on our hands due to the Covid19 crisis, we're reviewing some of our techniques and equipment...making sure everything works and was put away right. Things like our Tyvek ground sheet.

We use this under our tent to reduce wear and tear on the tent, and even help protect our Neo-air mattresses--this after we found a couple of pin-hole pricks in those air mattresses after a night on a bed of pine needles.

Of course you want to fold up your ground sheet into as small a package as possible, but there is also that old physics/math problem: you can't fold any piece of paper (or other material) more than seven times.

Here's our solution for getting your ground sheet into a nice, tidy, and small package.

First make sure it is dry and clean. In the rain, all bets are off. Stuff and go.

The first fold is across the longitudinal axis--making it half as long, but still as wide.

The second fold goes the other way, so that now you have two edges that have folds on them, and two that do not. That's important. Keeping those unfolded edges clear is how you make sure you fold all the air out of your ground sheet.

Fold one more time, again, back along the longitudinal axis.

You now have a ground sheet that is roughly 1/8 the size of the original. Good.

Now the truly tricky part. Fold the thing in thirds, folding first the side with the open edges and then the side with the folds on the edge. This gives you a long strip of ground sheet, almost like a tube, and the only open edges are at the end of the long strip.

Now the second secret. Begin to fold this long strip from the folded end towards the open edges end. Fold over about 1/5 or 1/4 off the ground sheet. Smooth out that fold, and do that again. This forms a nice, tidy block at the top of the strip, and still leaves the open edges at the bottom.

Now begin rolling from the folded section towards the open edged end. It will roll into a very tidy package.

Stuff it into your pack, and look for a way to wash your hands. It's too late, You've already packed everything up, the ground sheet was what you used to keep everything clean while you folded and stuffed everything else into your pack.

But everybody is waiting for you.

Time to hit the trail.

Next up--how to get that tent back into the bag it shipped in


check out our website:" onclick=";return false;

User avatar
Wandering Daisy
Topix Docent
Posts: 5072
Joined: Sun Jan 24, 2010 8:19 pm
Experience: N/A
Location: Fair Oaks CA (Sacramento area)

Re: Ground sheet origami

Post by Wandering Daisy » Tue Apr 28, 2020 9:17 am

I just fold once so that the width fits horizontally in my pack, then roll it up and stuff it in that empty space created by the round sleeping bag in the bottom of the pack. Easy, no fuss.

User avatar
Topix Expert
Posts: 960
Joined: Sat Nov 11, 2017 4:17 pm
Experience: Level 4 Explorer

Re: Ground sheet origami

Post by bobby49 » Tue Apr 28, 2020 12:36 pm

My cuben fiber ground sheet does not require critical folding, and it still fits into my shirt pocket.

User avatar
Topix Regular
Posts: 305
Joined: Wed Nov 13, 2013 5:17 pm
Experience: N/A

Re: Ground sheet origami

Post by robow8 » Tue Apr 28, 2020 2:56 pm

Currently using polycryo for a footprint, but the folding is the same for everything I use. First fold is always folding the bottom together, so that if it's dirty/muddy/wet, it's folded in on itself. From then on, it probably gets folded a different way every time.

Post Reply

Who is online

Users browsing this forum: No registered users and 5 guests