Page 1 of 1

Cleaning and Drying a Synthetic Hat Without it Shrinking?

Posted: Fri May 04, 2007 7:30 pm
by rightstar76
This is a repeat of a question I posted just hours before the board went down two weeks ago. I apologize for reposting it but I thought maybe nobody had seen it so I thought I would try again.

I had to buy a new R.E.I. Sahara Cape Hat after washing and drying the one I used to have. I had washed it in the past but I couldn't remember if I washed it cold or warm. I do know I made a mistake putting it into the dryer this time as I had never done that before. So I'm not sure if it was only the dryer that did it or if it was also the warm water. I prefer to use warm water when washing as it does a better job getting out the sweat stains and smell than cold water. But I don't want to have to go back to R.E.I. to buy another hat if I shrink the one that I currently have.

The hat is made of the following: The label reads: Crown 100% nylon and the Sweatband 100% Coolmax polyester. There is no care instruction label.

Posted: Fri May 04, 2007 9:58 pm
by ERIC
Sorry for the down-time. I hope someone here can answer your question. :)

Re: Cleaning and Drying a Synthetic Hat Without it Shrinking

Posted: Sat May 05, 2007 7:43 pm
by BSquared
rightstar76 wrote:...The label reads: Crown 100% nylon and the Sweatband 100% Coolmax polyester. There is no care instruction label.
The Coolmax website says:
Do garments made from Coolmax® require special care?
Most garments made with Coolmax® fabrics are machine washable and dryable; however, fabric softeners and chlorine bleach should not be used. Some garments may require special care because of the garment style, not the fabric. It is best to read the care label inside the garment.

Energy Saving Tip! > Because Coolmax® is so quick drying, you really don't need to use your dryer. If you've got clothes made from 100% Coolmax®, just hang 'em up to dry and be amazed at how quick it happens! Great tip for travel too!
Not much help, eh? I usually try to wash all my polyester stuff cold and keep it out of the drier, for whatever that's worth...

Posted: Sat May 12, 2007 9:58 pm
by rightstar76
Thanks Eric for letting me repost. Thanks BSquared for answering!