Marmot EOS 1P vs. MSR Hubba NX-1

Share your advice and personal experiences, post a gear review or ask any questions you may have pertaining to outdoor gear and equipment.
Post Reply
User avatar
John Harper
Topix Expert
Posts: 458
Joined: Wed Dec 15, 2010 11:54 am
Experience: N/A

Marmot EOS 1P vs. MSR Hubba NX-1

Post by John Harper »

Looking at these two tents, specs almost the same. Marmot a bit less price. Anybody have either one? I've seen a couple Hubbas, like the side entrance and able to sit up, even cook with fly partially open.

John
User avatar
oldranger
Topix Addict
Posts: 2861
Joined: Fri Jan 19, 2007 9:18 pm
Experience: N/A
Location: Bend, Oregon

Re: Marmot EOS 1P vs. MSR Hubba NX-1

Post by oldranger »

John,

Looking at the specs and construction of each plus reviews I think I would choose the NX-1. Primarily because of the "real" headroom created by the center crosspiece. One reviewer of the EOS noted how his head hit the netting when sitting up. The cross piece in the NX-1 should prevent that. However you should note that in the event of a snowstorm the flatter top of the NX-1 would require you to be alert to shaking snow off the top at regular intervals. Both are reasonable alternative with similar design but a little heavier than the much more expensive Big Sky Evolution I purchased and used last summer. I really appreciated having two doors and the ability to have cross ventilation in the Evolution, something that neither of the above tents have.

Mike
Mike

Who can't do everything he used to and what he can do takes a hell of a lot longer!
User avatar
John Harper
Topix Expert
Posts: 458
Joined: Wed Dec 15, 2010 11:54 am
Experience: N/A

Re: Marmot EOS 1P vs. MSR Hubba NX-1

Post by John Harper »

Mike,

Thanks for the advice. Took a peek at the Blue Sky website you posted. I'll have to peruse the options and see if that's an affordable alternative. I don't spend that many nights out, so $200 seemed reasonable for the Marmot or MSR. I remember reading about the headroom issue on the Marmot. My buddy who is taller than me really liked his MSR cause he could sit up. I'm only 5'8", so not as much an issue. I think they carry the Marmot over at the REI in Encinitas, only about 10 minute drive, so hopefully I can see one set up.

Thanks again,

John
User avatar
oldranger
Topix Addict
Posts: 2861
Joined: Fri Jan 19, 2007 9:18 pm
Experience: N/A
Location: Bend, Oregon

Re: Marmot EOS 1P vs. MSR Hubba NX-1

Post by oldranger »

Jphn

Always a good idea to try one set up. If you can also slide in a sleeping pad like the one you use to get full sense of headroom.

Mike
Mike

Who can't do everything he used to and what he can do takes a hell of a lot longer!
User avatar
balance
Topix Regular
Posts: 200
Joined: Sun May 04, 2014 12:26 am
Experience: N/A

Re: Marmot EOS 1P vs. MSR Hubba NX-1

Post by balance »

I'd like to say something about the Hubba and MSR.

I've got a Hubba tent, about eight years old, and the thing just won't quit. It's a little outdated now, but still does a good job going up above treeline.

As for MSR: The original Hubba rainfly developed this weird stickiness after six years. I am really careful about drying gear and storing it properly, so it wasn't mildew. When I called MSR and described the problem, the MSR representative immediately offered to send a replacement, which they did. It's been working great. That is good service.

Then two years ago, I got up in the middle of the night, leaned on my tent to catch my balance, and broke a tentpole. I used a stake and some tape to fix it, and continued my trip. When I got home, I emailed MSR and told them that I had leaned on my tent and broke a tent pole. I asked them how much a repair or replacement would cost. They said to send in the broken poles, and they would send me an entire set of new poles free of charge, which they did. That is really great service beyond what I would expect. I'm glad to give MSR the credit they deserve for being so helpful.

Peace.
User avatar
zacjust32
Topix Regular
Posts: 362
Joined: Thu Apr 16, 2015 12:50 pm
Experience: Level 3 Backpacker
Location: Fresno, Ca
Contact:

Re: Marmot EOS 1P vs. MSR Hubba NX-1

Post by zacjust32 »

balance wrote:As for MSR: The original Hubba rainfly developed this weird stickiness after six years. I am really careful about drying gear and storing it properly, so it wasn't mildew. When I called MSR and described the problem, the MSR representative immediately offered to send a replacement, which they did. It's been working great. That is good service.
Had the exact same experience, now on fly #3. They keep sending them and I keep using them, just something to note.
User avatar
John Harper
Topix Expert
Posts: 458
Joined: Wed Dec 15, 2010 11:54 am
Experience: N/A

Re: Marmot EOS 1P vs. MSR Hubba NX-1

Post by John Harper »

Those are strong recommendations for MSR, thanks.

John
Post Reply

Who is online

Users browsing this forum: No registered users and 23 guests